Agilent Technologies ENA Series Guia do Utilizador descarregar pdf (Página 598)

592 Appendix A

Manual Changes

Figure A-4 Calibration kit definition screen

Step 2. Define each standard as follows

Reference impedance (Z0)

Enter a value of the reference impedance of thru, line and match (1 in Figure A-4).

Select a standard type (2 in Figure A-4) and enter a delay value (3 in Figure A-4) in ps.

Enter a delay value (4 in Figure A-4) in ps. If necessary, also enter its offset loss value (5 in

Figure A-4) in Gohm/sec.

Enter a frequency range (6 in Figure A-4) in GHz. Check the match you use for calibration

(7 in Figure A-4).

You can define 3 lines: Line 1, Line 2, and Line 3.

Enter a delay value (8 in Figure A-4) in ps and enter a frequency range (9 in Figure A-4) in

Check the lines you use for calibration (7 in Figure A-4).

Sem comentários

Agilent Technologies ENA Series Guia do Utilizador Página 598