Agilent Technologies 2000 X-Series Manual de Serviço descarregar pdf (Página 605)

:TRIGger Commands 29

Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 605

:TRIGger[:EDGE]:SLOPe

(see page 790)

Command Syntax

:TRIGger[:EDGE]:SLOPe <slope>

<slope> ::= {NEGative | POSitive | EITHer | ALTernate}

The :TRIGger[:EDGE]:SLOPe command specifies the slope of the edge for

the trigger. The SLOPe command is not valid in TV trigger mode. Instead,

use :TRIGger:TV:POLarity to set the polarity in TV trigger mode.

Query Syntax

:TRIGger[:EDGE]:SLOPe?

The :TRIGger[:EDGE]:SLOPe? query returns the current trigger slope.

Return Format

<slope> ::= {NEG | POS | EITH | ALT}

See Also • "Introduction to :TRIGger Commands" on page 589

• ":TRIGger:MODE" on page 598

• ":TRIGger:TV:POLarity" on page 624

Example Code

' TRIGGER_EDGE_SLOPE - Sets the slope of the edge for the trigger.

' Set the slope to positive.

myScope.WriteString ":TRIGGER:EDGE:SLOPE POSITIVE"

See complete example programs at: Chapter 38, “Programming Examples,”

starting on page 799

Sem comentários

Agilent Technologies 2000 X-Series Manual de Serviço Página 605