Agilent Technologies 2000 X-Series Manual de Serviço descarregar pdf (Página 600)

600 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide

29 :TRIGger Commands

:TRIGger:SWEep

(see page 790)

Command Syntax

:TRIGger:SWEep <sweep>

<sweep> ::= {AUTO | NORMal}

The :TRIGger:SWEep command selects the trigger sweep mode.

When AUTO sweep mode is selected, a baseline is displayed in the absence

of a signal. If a signal is present but the oscilloscope is not triggered, the

unsynchronized signal is displayed instead of a baseline.

When NORMal sweep mode is selected and no trigger is present, the

instrument does not sweep, and the data acquired on the previous trigger

remains on the screen.

Query Syntax

:TRIGger:SWEep?

The :TRIGger:SWEep? query returns the current trigger sweep mode.

Return Format

<sweep> ::= current trigger sweep mode

See Also • "Introduction to :TRIGger Commands" on page 589

This feature is called "Mode" on the instrument's front panel.

Sem comentários

Agilent Technologies 2000 X-Series Manual de Serviço Página 600