Agilent Technologies 2000 X-Series Manual de Serviço descarregar pdf (Página 356)

100

101

356 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide

20 :MEASure Commands

:MEASure:PHASe

(see page 790)

Command Syntax

:MEASure:PHASe [<source1>][,<source2>]

<source1>, <source2> ::= {CHANnel<n> | FUNCtion | MATH | WMEMory<r>}

<n> ::= 1 to (# analog channels) in NR1 format

<r> ::= 1-2 in NR1 format

The :MEASure:PHASe command places the instrument in the continuous

measurement mode and starts a phase measurement.

Query Syntax

:MEASure:PHASe? [<source1>][,<source2>]

The :MEASure:PHASe? query measures and returns the phase between the

specified sources.

A phase measurement is a combination of the period and delay

measurements. First, the period is measured on source1. Then the delay is

measured between source1 and source2. The edges used for delay are the

source1 rising edge used for the period measurement closest to the

horizontal reference and the rising edge on source 2. See :MEASure:DELay

for more detail on selecting the 2nd edge.

The phase is calculated as follows:

phase = (delay / period of input 1) x 360

Return Format

<value> ::= the phase angle value in degrees in NR3 format

See Also • "Introduction to :MEASure Commands" on page 340

• ":MEASure:DELay" on page 347

• ":MEASure:PERiod" on page 355

• ":MEASure:SOURce" on page 361

1 2 ... 351 352 353 354 355 356 357 358 359 360 361 ... 929 930

Comentários a estes Manuais

Sem comentários

Agilent Technologies 2000 X-Series Manual de Serviço Página 356

Comentários a estes Manuais

Manuais e produtos relacionados com Multímetros Agilent Technologies 2000 X-Series