Agilent Technologies 1100 Series Manual de Serviço descarregar pdf (Página 262)

262 1100 Series DAD and MWD Reference Manual

6 Introduction to the Detector

In the non-volatile memory, the parameters are kept, regardless of whether

you turn the instrument off and on again. They will be kept until the same set

of parameters is changed and the power is reset. All other previously stored

configuration settings will still remain in the non-volatile memory.

In this way, you can store more than one set of parameters using the same

8-bit configuration switch twice, for example, for both GPIB and RS-232C.

GPIB Default Addresses

If you just want to change the GPIB address and need a detailed procedure,

refer to the Installing Your Agilent ChemStation System handbook.

Default GPIB address is set to the following addresses:

where 0 means that the switch is down and 1 means that the switch is up.

Table 4 1 Default Addresses for Agilent Series 1100 Modules

Module Address Binary Address

Pump 22 0 0 0 1 0 1 1 0

FLD 23 0 0 0 1 0 1 1 1

VWD 24 0 0 0 1 1 0 0 0

Agilent 8453 25 0 0 0 1 1 1 0 1

DAD/MWD 26 0 0 0 1 1 0 1 0

Column compartment 27 0 0 0 1 1 0 1 1

Autosampler 28 0 0 0 1 1 1 0 0

RID 29 0 0 0 1 1 1 0 1

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 317 318

Sem comentários

Agilent Technologies 1100 Series Manual de Serviço Página 262