Agilent Technologies 1100 Series Manual de Serviço descarregar pdf (Página 146)

146 1100 Series DAD and MWD Reference Manual

4 Repairing the Detector

Entering the Serial Number using the Control Module

1 Connect the control module to the detector. Turn on the detector.

2 In the control module, press System (F5), then Records (F4). Using the

up/down arrows, make sure that the detector is highlighted.

3 Press FW Update (F5). Now, press the m key. This will display a box which

says Update Enter Serial#.

4 Press Enter. This will display the box labeled Serial#.

5 Alphabetic characters and numbers are created using the up and down

arrows. In the box labeled Serial#, enter the 10-character serial number for

the detector. When the 10-character serial number is entered, press Enter

to highlight the complete serial number. Then, press Done (F6).

6 Turn the detector off, then on again. The Records screen should display the

correct serial number for this module.

7 If a Agilent ChemStation is also connected, restart the Agilent ChemStation

now as well.

NOTE

For firmware revisions below A.02.00 it is important never to press Done if the Serial# box

is blank. In this case, the module can no longer be recognized by either the control module

or the Agilent ChemStation. The main board must then be replaced.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 317 318

Sem comentários

Agilent Technologies 1100 Series Manual de Serviço Página 146