Agilent Technologies 8935 Series Manual do Utilizador descarregar pdf (Página 54)

54 Chapter 2

O:\Manuals\E6380A_Progguid\Book\Measrslt.fm

Methods For Reading Measurement Results

RMB ‘ON TIMEOUT’ Example Program

The following example program demonstrates a recommended

technique which can be utilized in situations where a measurement

result time-out value of 32.767 seconds or less is adequate. In the RMB

language, the time-out parameter for the ON TIMEOUT command has

a maximum value of 32.767 seconds. If a time-out value of greater than

32.767 seconds is required refer to the “RMB ‘MAV’ Example Program”

on page 58.

The measurement result time-out value is defined to mean the amount

of time the control program is willing to wait for the Test Set to return a

valid measurement result to the control program.

Lines 10 through 230 in this example set up a measurement situation

to demonstrate the use of the recommended technique. The

recommended technique is exampled in the Measure Function.

NOTE

Lines 50 and 60 should be included in the beginning of all control

programs. These lines are required to ensure that the Test Set is

properly reset. This covers the case where the program was previously

run and was stopped with the Test Set in an error condition.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 328 329

Sem comentários

Agilent Technologies 8935 Series Manual do Utilizador Página 54