Agilent Technologies 8935 Series Manual do Utilizador descarregar pdf (Página 37)

Chapter 1 37

Using HP-IB

Getting Started

Preparing the Test Set For HP-IB Use

1. If other HP-IB devices are in the system, attach an HP-IB cable from

the Test Set’s HP-IB connector to any one of the other devices in the

test system.

2. Access the I/O CONFIGURE screen and perform the following steps:

a. Set the Test Set’s HP-IB address using the HP-IB Adrs field.

b. Set the Test Set’s HP-IB controller capability using the Mode field.

• Talk&Listen configures the Test Set to not be the System

Controller. The Test Set has Active Controller capability (take

control/pass control) in this mode. Use this setting if the Test

Set will be controlled through HP-IB from an external

controller.

• Control configures the Test Set to be the System Controller.

Use this setting if the Test Set will be the only controller on

the HP-IB. Selecting the Control mode automatically makes

the Test Set the Active Controller.

NOTE

Only one System Controller can be configured in an HP-IB system.

Refer to “Passing Control” on page 186 for further information.

3. If an HP-IB printer is or will be connected to the Test Set’s HP-IB

connector then,

a. access the PRINT CONFIGURE screen.

b. select one of the supported HP-IB printer models using the Model

field.

c. set the Printer Port field to HP-IB.

d. set the printer address using the Printer Address field.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 328 329

Sem comentários

Agilent Technologies 8935 Series Manual do Utilizador Página 37