Agilent Technologies 8935 Series Manual do Utilizador descarregar pdf (Página 245)

Chapter 8 245

IBASIC Controller

Method #1. Program Development on an External BASIC Language Computer

HP BASIC for Windows PC Configuration for

Windows NT Operating System

To prepare for HP BASIC program development utilizing Windows NT,

the external PC must be configured to operate with the Test Set.

You will need:

• an Agilent Technologies 82341B/C interface card (the Agilent

Technologies 82335 card does not support Windows NT)

How to install:

1. Install the 82341B/C into an open expansion slot. Refer to the

interface card’s installation guide details. Utilize the default card

settings.

2. Install the SICL libraries using the SETUP32.EXE setup file.

3. Run the SICL I_O Config program to configure the card.

4. Select 82340/82341 HP-IB from the available interface list of choices.

5. Select the Configure command button. Use the default settings

shown by the program. This will verify that the card is functioning.

6. Install HP BASIC for Windows 6.3 or later.

7. Run HP BASIC for Windows.

8. Edit the AUTOST file, change line 330 as follows:

Example 8-2 Example

LOAD BIN "HPIBS;DEV hpib7" !SICL Library for HP 82341 card

9. Re-store the AUTOST file

10.Quit HP BASIC for Windows

11.Run HP BASIC for Windows. The program should load normally and

allow you to send orders to the Test Set.

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 328 329

Sem comentários

Agilent Technologies 8935 Series Manual do Utilizador Página 245