Agilent Technologies 8935 Series Manual do Utilizador descarregar pdf (Página 260)

260 Chapter 8

O:\Manuals\E6380A_Progguid\Book\Ibasic.fm

IBASIC Controller

Method #3. Developing Programs Using Word Processor on a PC (Least Preferred)

Sending ASCII Text Files Over RS-232 With

HyperTerminal

Set up the HyperTerminal emulator software on the PC as covered in

“Setting Up HyperTerminal on your PC (Windows Version 3.1)” on page

235. Load and run the ASCII_DN download program in the Test Set’s

IBASIC controller. When the prompt Ready to receive ASCII file

data is displayed on the Test Set, make the following settings in

HyperTerminal on the PC:

1. Select Settings.

2. Select Text Transfers.

3. Select Flow Control: Standard Flow Control.

4. Select Word Wrap Outgoing Text at Column: unselected.

• This will use Xon/Xoff flow control by default.

5. Select OK.

6. Select Transfers.

7. Select Send Text File.

8. Set Strip LF off and Append LF off. (It is important that the line

feeds that are in the ASCII file not be stripped or the file transfer

will not work).

9. Select or enter the file name to transfer.

10.Begin the transfer by selecting OK.

At this point, each line of the program will rapidly scroll across the

screen of the Test Set. When the transfer is finished, the prompt Down

load of ASCII file complete. will be displayed on the Test Set.

Before running the downloaded program, execute a SCRATCH

command on the IBASIC Command Line to remove the ASCII_DN

download program from Test Set memory.

Next, execute a GET TEMP_CODE command on the IBASIC Command

Line. This will load the ASCII text into the IBASIC program memory.

Finally, execute a RUN command on the IBASIC Command Line. This

will run the program. If any syntax errors are present in the program

IBASIC will generate the appropriate error messages.

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 328 329

Sem comentários

Agilent Technologies 8935 Series Manual do Utilizador Página 260