Agilent Technologies 8935 Series Manual do Utilizador descarregar pdf (Página 44)

44 Chapter 1

O:\Manuals\E6380A_Progguid\Book\Usehpib.fm

Using HP-IB

Addressing

Factory Set Address

The Test Set’s HP-IB address is set to decimal 14 at the factory. The

address can be changed by following the instructions in “Setting the

Test Set’s Bus Address” on page 44.

Extended Addressing

Extended addressing (secondary command) capability is not

implemented in the Test Set.

Multiple Addressing

Multiple addressing capability is not implemented in the Test Set.

Setting the Test Set’s Bus Address

The Test Set’s HP-IB bus address is set using the HP-IB Adrs field

which is located on the I/O CONFIGURE screen. To set the HP-IB bus

address; select the I/O CONFIGURE screen and position the cursor

next to the HP-IB Adrs field. The address can be set from decimal 0 to

30 using the numeric DATA keys, or by pushing and then rotating the

Cursor Control knob. There are no DIP switches for setting the HP-IB

bus address in the Test Set. The new setting is retained when the Test

Set is turned off.

Displaying the Bus Address

The Test Set’s HP-IB bus address can be displayed by pressing and

releasing the SHIFT key, then the LOCAL key. The address is displayed

in the upper left-hand corner of the display screen.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 328 329

Sem comentários

Agilent Technologies 8935 Series Manual do Utilizador Página 44