Agilent Technologies 8935 Series Manual do Utilizador descarregar pdf (Página 248)

248 Chapter 8

O:\Manuals\E6380A_Progguid\Book\Ibasic.fm

IBASIC Controller

Method #1. Program Development on an External BASIC Language Computer

After the above commands complete the program code will be in the

Test Set ready to run. If any bugs are detected when the program is

run, the program can be uploaded back into the external BASIC

language controller to correct the error. Alternately the full screen

IBASIC EDIT function through RS-232 can be used to correct the error

(refer to “Method #2. Developing Programs on the Test Set Using the

IBASIC EDIT Mode” on page 250 for details).

After the program is working properly in the Test Set IBASIC

environment, it should be stored for backup purposes.

Uploading Programs from the Test Set to an External

BASIC Controller through HP-IB

To upload a program from the Test Set to an external BASIC language

controller through HP-IB the following program, which uses a

command from the PROGram subsystem to initiate the upload, must be

running on the external BASIC language controller. The uploaded

program is stored to a file specified by the user.

In the following program the external BASIC language controller is a

PC running TransEra HT BASIC. The file is stored to the C:\HTB386

directory. If the external BASIC language controller is an HP 9000

Series 200/300 Workstation, modify the mass storage volume specifier

appropriately. After running the program, the uploaded program code

will be in the designated file. Use the GET command to retrieve the file

for editing.

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 328 329

Sem comentários

Agilent Technologies 8935 Series Manual do Utilizador Página 248