Agilent Technologies 1100 Series Manual de Instruções descarregar pdf (Página 27)

1100 Series Capillary LC System Manual 17

Installing your Capillary LC System 1

Install the Thermostatted Column Compartment (TCC) (G1316A)

1 Ensure that the line power switch at the front of the thermostatted column

compartment (TCC) is off.

2 Place the TCC on top of the micro sampler. Make sure that the two modules

are interlocked correctly.

3 Connect the Can-bus cable (5181-1516) to one of the CAN connectors at the

rear of the TCC.

4 Connect the power cable to the power socket at the rear of the TCC. Do not

connect the power cable to power until you have finished the hardware

installation of all modules in the stack.

5 Connect the free end of the Can-bus cable from the micro sampler to the

unused Can-bus connector at the rear of the TCC.

6 Place the analytical column into the TCC. Observe the flow direction

indicated on the column. The column can later be secured using column

clamp (5001-3702).

7 Connect the free end of sampler-to-column capillary (G1375-87304) to the

inlet of the analytical column in the TCC.

WARNING

Connect the power cable to power only after you have finished the hardware

installation of all modules in the stack.

NOTE

Carefully route all capillaries so that they are not crushed or broken by module front covers.

Avoid excessive bending. See Chapter 2 for advice on handling capillaries.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 195 196

Sem comentários

Agilent Technologies 1100 Series Manual de Instruções Página 27