Agilent Technologies 1100 Series Manual de Instruções descarregar pdf (Página 24)

14 1100 Series Capillary LC System Manual

1 Installing your Capillary LC System

Installing a Capillary LC System with a Thermostatted Micro Sampler

These instructions will produce two stacks of modules. The left-hand stack

will consist of the capillary pump, degasser and solvent cabinet. The

right-hand stack will consist of the thermostatted micro sampler (bottom),

thermostatted column compartment (TCC), and diode array detector (DAD)

on top.

Required cables, tubes and capillaries for each module are included with the

system shipment, or found in the module accessory kits.

Refer to Chapter 3 for detailed information on system plumbing connections,

and Agilent part numbers and descriptions for capillaries throughout the

system.

This manual provides an overview of the entire Capillary LC System. For more

detailed information about each module, refer to the reference manual

provided with each module.

NOTE

The Agilent part numbers for capillaries indicated in the text are intended for use with the

standard capillary pump, as the pump is shipped from the factory. If the optional Extended

Flow Range Kit (G1376-68707) is to be installed in the pump, several of these capillaries,

throughout the entire system, will be changed. Refer to chapter 6 for detailed information

on the Extended Flow Range Kit.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 195 196

Sem comentários

Agilent Technologies 1100 Series Manual de Instruções Página 24