Agilent Technologies 1100 Series Manual de Instruções descarregar pdf (Página 17)

1100 Series Capillary LC System Manual 7

Installing your Capillary LC System 1

Installing a Capillary LC System with a Non-Thermostatted Sampler

These instructions will produce a single stack of modules, with the Diode

Array Detector (DAD) on the bottom. Required cables, tubes and capillaries

for each module are included with the system shipment, or found in the

module accessory kits.

Refer to Chapter 3, “Capillaries and Fittings,” starting on page 45 for detailed

information on system plumbing connections, and Agilent part numbers and

descriptions for capillaries throughout the system.

This manual provides an overview of the entire Capillary LC System. For more

detailed information about each module, refer to the reference manual

provided with each module.

NOTE

The Agilent part numbers for capillaries indicated in the text are intended for use with the

standard capillary pump, as the pump is shipped from the factory. If the optional Extended

Flow Range Kit (G1376-68707) is to be installed in the pump, several of these capillaries,

throughout the entire system, will be changed. Refer to chapter 6 for detailed information

on the Extended Flow Range Kit.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 195 196

Sem comentários

Agilent Technologies 1100 Series Manual de Instruções Página 17