Agilent Technologies InfiniiVision 6000 Series Manual de Serviço descarregar pdf (Página 592)

100

101

592 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TRIGger:SEQuence:TRIGger

(see page 798)

Command Syntax

:TRIGger:SEQuence:TRIGger <value>

<value> ::={PATTern2,ENTered | PATTern2,EXITed | EDGE2

| PATTern2,AND,EDGE2 | EDGE2,COUNt | EDGE2,COUNt,NREFind}

The :TRIGger:SEQuence:TRIGger command specifies the trigger stage of a

sequence trigger. The sequence commands set various search terms. After

all of these are found in sequence, the trigger condition itself is searched

for. This command accepts three program data parameters; you can use

NONE to fill out the parameter list (for example, "EDGE2,NONE,NONE").

PATTern2 is specified with the :TRIGger:SEQuence:PATTern command.

EDGE2 is specified with the :TRIGger:SEQuence:EDGE command. COUNt is

specified with the :TRIGger:SEQuence:COUNt command.

Query Syntax

:TRIGger:SEQuence:TRIGger?

The :TRIGger:SEQuence:TRIGger? query returns the trigger stage

specification for a sequence trigger. NONE is returned for unused

parameters.

Return Format

<trigger_value><NL>

<trigger_value> ::= {PATT2,ENT,NONE | PATT2,EXIT,NONE

| EDGE2,NONE,NONE | PATT2,AND,EDGE2

| EDGE2,COUN,NONE | EDGE2,COUN,NREF}

See Also • "Introduction to :TRIGger Commands" on page 479

• ":TRIGger:SEQuence:PATTern" on page 589

• ":TRIGger:SEQuence:EDGE" on page 587

• ":TRIGger:SEQuence:COUNt" on page 586

• ":TRIGger:SEQuence:FIND" on page 588

• ":TRIGger:SEQuence:RESet" on page 590

1 2 ... 587 588 589 590 591 592 593 594 595 596 597 ... 933 934

Comentários a estes Manuais

Sem comentários

Agilent Technologies InfiniiVision 6000 Series Manual de Serviço Página 592

Comentários a estes Manuais

Manuais e produtos relacionados com Multímetros Agilent Technologies InfiniiVision 6000 Series