Agilent Technologies 1100 Series Manual do Utilizador descarregar pdf (Página 70)

Repair and Maintenance

Recovering from an Operating System Crash

1 Open the Bootp Server window by clicking on it in the task bar.

2 Now turn on the VW detector on the LAN and view the Bootp Server window.

After 2 - 10 seconds the Bootp Server will display the request from the

JetDirect card with the hardware (MAC) address (this information is also

stored in the file trace.txt in the bootp server directory, if Log to Disk is

enabled), see Figure 39.

The MAC or hardware address of the JetDirect card is a world wide unique

identifier. No other network device will have the same hardware address.

Figure 39 Bootp Server

3 Select Configure -> Add Entry to configure the Bootp Manager. The drop

down box “MAC address” lists automatically the MAC address of the installed

JetDirect card (Figure 40 on page 71).

If no hardware address is found, select Cancel and repeat step 2 and step 3.

4 Specify the Host Name

+3, the IP address , the Comment, e.g.

/&and the Subnet Mask 

NOTE If you are working in a network system, you may need other addresses.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 76

Sem comentários

Agilent Technologies 1100 Series Manual do Utilizador Página 70