Agilent Technologies 1100 Series Manual do Utilizador descarregar pdf (Página 68)

Repair and Maintenance

Recovering from an Operating System Crash

5 Select No to the usage of DHCP and use C:\I386 as the location of your

Windows NT 4.0 installation files on your hard disk.

After the file copying is finished, select the Bindings tab, to allow NT to

associate the TCP/IP protocol with your installed network adapter.

6 Open the Protocols tab again and select TCP/IP from the list of installed

protocols. Press the Properties button to configure the TCP/IP, see Figure 38

on page 68.

Figure 38 TCP/IP Configuration Screen - Changing Properties

7 Specify as IP address

 and for the subnet mask .

NOTE If you are working in a network system, you may need other addresses.

8 Now select the bindings tab again, to allow the operating system to associate

the configured protocols to the configured network adapters. Select OK and

restart your PC to activate the changes.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 74 75 76

Sem comentários

Agilent Technologies 1100 Series Manual do Utilizador Página 68