Agilent Technologies 1100 Series Manual do Utilizador descarregar pdf (Página 13)

General information about your system

Site Requirements

Bench Space

The modules’ dimensions and weight (see Table 2 on page 14) allow to place

the modules on almost any desk or laboratory bench. It needs an additional

2.5 cm (1.0 inches) of space on either side and approximately 8 cm

(3.1 inches) in the rear for the circulation of air and electric connections.

If the bench should carry a complete system, make sure that the bench is

designed to carry the weight of all the modules.

The modules should be operated in a horizontal position.

Environment

Your modules will work within specifications at ambient temperatures and

relative humidity as described in Table 2 on page 14.

Detectors

ASTM drift tests require a temperature change below 2 °C/hour (3.6 °F/hour)

over one hour period. Our published drift specification (refer also to

“Performance Specifications” in your detector’s reference manuals) is based

on these conditions. Larger ambient temperature changes will result in larger

drift. Better drift performance depends on better control of the temperature

fluctuations. To realize the highest performance, minimize the frequency and

the amplitude of the temperature changes to below 1 °C/hour (1.8 °F/hour).

Turbulences around one minute or less can be ignored.

CAUTION Do not store, ship or use your modules under conditions where temperature

fluctuations could cause condensation within the modules. Condensation will

damage the system electronics. If your modules were shipped in cold weather,

leave them in their boxes and allow them to warm slowly to room temperature

to avoid condensation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Sem comentários

Agilent Technologies 1100 Series Manual do Utilizador Página 13