Agilent Technologies 53230A Especificações descarregar pdf (Página 218)

Chapter 4 Retrofitting Options

To Retrofit the 53210A Channel 2 Rear Panel Input, 6.0 GHz (Option 106)

or 15.0 GHz (Option 115) plus Rear Panel Option 203

218 Assembly-Level Service Guide

6 Assemble the parts in the Option 106/115 package as follows:

NOTE Refer as necessary to Figure 4-14.

– If Option 115 is being installed, insert and tighten the two

supplied standoffs (using a 1/4" spintite) in the two middle

holes closest to the front flange of the Channel 2 assembly

(Rear Panel Option 203 only).

– Position the printed circuit board over the aluminum

bracket so that the SMA edge connector is pointed toward

the rear flange (with the hole in it) and sits on top of the

standoffs.

– Install 4 (Option 106) or 6 (Option 115) T10 TORX screws to

secure the printed circuit board to the aluminum deck.

Figure 4-14. 53210A Channel 2 Rear Panel Option 106/203

Front

Flange

Rear

Flange

Label

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 259 260

Sem comentários

Agilent Technologies 53230A Especificações Página 218