Agilent Technologies N4962A Guia do Utilizador descarregar pdf (Página 26)

System Details and Performance Specifications

Serial BERT 12.5 Gb/s User Guide

Table 3. Parameters for N4962A internal low-frequency clock (LF TrigO, Ext CKI)

Frequency

615.625 to 709.375 MHz

Max input amplitude

Ext CKI: 2.0

Vpp (+10 dBm)

Output power

LF TrigO, 0.5 V pp typical

Connector

Female SMA, single-ended, AC coupled, 50 Ω impedance

The LF 1/16th rate clock must phase lock to the data rate clock.

The LF clock is multiplied up to HF clock frequencies and is split into two

output paths: a transmit clock for the PRBS generator, TX CKO, which can be

modulated with an external jitter input signal, and a receive clock for the error

detector, RX CKO. Both outputs are buffered. The clock outputs are connected

by default to the input clock connectors for the PRBS generator and error

detector, TX CKI and RX CKI, with a pair of coaxial cable loops.

To trigger the PRBS generator and error detector with an external 500 MHz to

12.5 GHz clock, remove the coax loops and apply the external source to TX CKI

and RX CKI. The generator and detector must be triggered with the same

phase-synchronous clock. Ensure that at least 0 dBm (630 mV pp) is applied to

the TXCKI input and at least +4 dBm (1 V pp) is applied to the RXCKI input. Do

not apply more than +10 dBm (2 V pp) to these inputs.

Table 4. Parameters for N4962A internal clock (TX CKO, RX CKO, HF TrigO)

Frequency

9.85 to 11.35 GHz

Resolution

10 MHz front-panel, 1 MHz GPIB

Output power

TX CKO, Typ: +4 dBm (1

V pp)

RX CKO, Typ: +4 dBm (1

V pp)

HF TrigO, Typ: +6 dBm (1.3

V pp)

Connector

Female SMA, single

-ended, AC coupled, 50 Ω impedance

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 87 88

Sem comentários

Agilent Technologies N4962A Guia do Utilizador Página 26