Agilent Technologies AGILENT U2761A Manual de Serviço descarregar pdf (Página 108)

9 Triggering Commands

100 U2761A Programmer’s Reference

OUTPut:TRIGger:SLOPe

Syntax

OUTPut:TRIGger:SLOPe {POSitive|NEGative}

This command sets the rising or falling edge for the “trigger out” signal at

the beginning of the sweep. When enabled using the

OUTPut:TRIGger[:STATe] command, a TTL- compatible Square waveform

with the specified edge is output from the Trig Out connector at the

beginning of the sweep.

OUTPut:TRIGger:SLOPe?

This query returns the selected trigger slope as POS or NEG.

Parameter

Remarks

• When the Immediate (internal) trigger source is selected, the U2761A

outputs a Square waveform with a 50% duty cycle from the Trig Out

connector at the beginning of the sweep. The period of the waveform is

equal to the specified sweep time.

• When the Bus (software) trigger source is selected, the U2761A outputs

a pulse from the Trig Out connector at the beginning of each sweep.

Item Type Range of values Default value

slope Discrete POSitive|NEGative POSitive

OUTP :TRIG space:SLOP POS

NEG

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 168 169

Sem comentários

Agilent Technologies AGILENT U2761A Manual de Serviço Página 108