Agilent Technologies 6634A Manual do Utilizador descarregar pdf (Página 76)

Connecting the DUT Power Supply Cables

Programming the GPIB Address on Faceless Supplies

To program a new GPIB address on a faceless supply

you must first determine its current address. Since the

current address for the supply is unknown, start by

turning off all other power supplies in the system to

assure that you do not have two devices at the same

GPIB address.

To determine the current GPIB address of the faceless

supply, type:

btio -hpib -scan Return (For the 725 controller)

btio -lanhpib -scan Return (For the 712 controller)

Once you know the current address of the faceless

supply, you can change its address with the following

command:

btio -hpib -set_addr <old address> <new

address>

Return (For the 725)

btio -lanhpib -set_addr <old address> <new

address>

Return (For the 712)

See

Table 9 on page 72 for the default GPIB addresses.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 82

Sem comentários

Agilent Technologies 6634A Manual do Utilizador Página 76