Agilent Technologies 6634A Manual do Utilizador descarregar pdf (Página 6)

Introduction

4 Update the system configuration file for the

additional DUT power supply.

Each step might be simple or complex depending on

your application and system. Choose the appropriate

instructions for each step from the pages that follow.

Tools Needed

■ Anti-static wrist strap

■ 2.5-millimeter hex wrench

■ 3-millimeter hex wrench

■ 5-millimeter hex wrench

■ #2 Pozidriv screwdriver

■ 1/4-inch flat blade screwdriver

■ T20 Torx driver

■ Diagonal cutters

■ System cabinet key

■ Testhead key

■ Right-angle ratchet driver

■ T15 Torx bit for ratchet driver

■ T20 Torx bit for ratchet driver

■ Needle-nose pliers

■ 7/16-inch box-end or open-end wrench

■ #2 Pozidriv ratchet or offset screwdriver

Preparation

CAUTION

✸

The procedures in this document must be

performed by personnel who are trained and

qualified to service Agilent 3070 / 79000 Family

systems.

Follow the steps below before beginning the

installation:

1 If the system is in use, notify the operator and system

administrator that testing must be suspended while

the DUT supply is installed. The testhead must be

shut down, but the controller can remain active for

use by programmers. Obtain permission before

shutting down the testhead.

2 Remove any test fixture that may be on the testhead.

3 Remove the board handler if it is installed on the

testhead.

CAUTION

✸

DO NOT rotate the testhead if an 44990A EFS

Board Handler is installed. The added weight of

the board handler might damage the testhead’s

rotating mechanism or cause the testhead to tip

over.

1 2 3 4 5 6 7 8 9 10 11 ... 81 82

Comentários a estes Manuais

Sem comentários

Agilent Technologies 6634A Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Sintetizador Agilent Technologies 6634A