Agilent Technologies 6634A Manual do Utilizador descarregar pdf (Página 41)

Installing DUT Power Supplies

5 Install the 6634A/B in the middle location, shown in

Figure 14, by setting the power supply in the middle

slot and using two screws to secure the mounting

bracket to the cradle DUT mounting support.

6 Using a #1 Pozidriv screwdriver and 2 dress screws

(0570-1366), secure the 6634A/B to the cradle DUT

mounting support using the rack mount ears as

shown in

Figure 16.

Figure 16 Power supply front mounting

7 If a 6624A supply needs mounted, go to 6624A DUT

Supply Installation. If a 6624A does not need

mounted, reinstall mounting bracket number #1. The

correct mounting is shown in

Figure 14 on page 36.

Face Down 6634A/B DUT Supply Installation

1 Using a #2 Pozidriv screwdriver remove power

supply mounting bracket #1, shown in

Figure 14 on

page 36, from power supply mounting bracket #2. If

a middle 6634A/B or an 6624A is already installed,

remove power supply mounting bracket #1 from

them and set the bracket and the screws aside for

later use. The middle 6634A/B will need to be

removed to install the face down 6634A/B.

2 Plug in the face down 6634A/B and set the GPIB

address to 3. Since front panel access is not possible

after mounting, this must be done before mounting

the power supply. See the section

Programming the

GPIB Address on Supplies with Front Panels on

page 72 for instructions.

3 The face down 6634A/B is mounted next to the

cradle. There are two mounting brackets included in

each Agilent 79000, one on each end of where the

face down 6634A/B is installed. Remove the

mounting brackets from the cradle frame, front and

rear, and attach them to the power supply using the

0515-0383 screws in the plastic bag tied to the cradle

DUT mounting support. First attach the 6634A/B

mounting bracket to the power supply using the

slotted holes, but do not tighten them. Insert the face

down 6634A/B with the GPIB connector toward the

front of the system and re-attach the mounting

brackets to the cradle frame, shown in

Figure 17 on

page 39, using two screws in both the front and rear

to secure the power supply to the cradle. Next tighten

the screws in the slotted holes to secure the power

supply to the cradle.

Cradle DUT

Mounting Support

662

Rack Mount Ears

with Dress Screws

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 81 82

Comentários a estes Manuais

Sem comentários

Agilent Technologies 6634A Manual do Utilizador Página 41

Comentários a estes Manuais

Manuais e produtos relacionados com Sintetizador Agilent Technologies 6634A