Agilent Technologies 6634A Manual do Utilizador descarregar pdf (Página 38)

Installing DUT Power Supplies

Installing the DUT Power Supplies in a 79000

System

These procedures describe how to install a DUT supply

in a 79000 testhead. The cables for both the 6624A and

6634A/B are installed in all 79000 testheads, even if

DUT supplies are not factory installed. All necessary

hardware is shipped attached to the cradle in the left pod

to install each of DUT supplies.

In the 79000 system, the DUT supplies are mounted in

the pod on the right end, when viewed from the back of

the system, as shown in

Figure 14 on page 36. The

6624A (E3785A faceless DUT power supply), and up to

two 6634A/Bs (1-output high voltage E4034A DUT

power supply) may be installed in the 79000 system. If

there is only one 6634A/B, it is installed in the middle

position. The face down 6634A/B is installed next to the

cradle wall. The 6624A is installed in the outside

position.

NOTE

If two 6634A/Bs are installed, the face down

6634A/B must be installed before the middle

6634A/B due to access constraints.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 81 82

Sem comentários

Agilent Technologies 6634A Manual do Utilizador Página 38