Agilent Technologies 1100 Series Guia de Instalação descarregar pdf (Página 7)

1100 LC Modules Control Manual - 7 - 03-914947-30:Rev.6

Ethernet Communications

The Agilent Technologies 1100 modules can use Ethernet ® as

the method of communications for instrument control and for

sending digital data to the external data system. Ethernet

communication is not standard on the Agilent 1100 chain. The

Ethernet connection is made at the back of the 1100 chain.

There are two types of Ethernet cables:

• An Ethernet crossover cable is used when the Agilent 1100

chain is connected directly to the Galaxie Acquisition Server

PC.

• A standard Ethernet patch cable is used when the Agilent

1100 chain is connected to a company Ethernet network.

The Agilent 1100 modules uses TCP/IP (Transmission Control

Protocol / Internet Protocol) to communicate over the Ethernet

network and needs to be given a unique IP address to identify

the instrument.

A BOOTP Server or a DHCP server is used to send IP

addresses to TCP/IP devices.

The BOOTP Server lists Ethernet addresses along with the IP

addresses that are to be assigned to the corresponding devices.

To known how to configure the BOOTP server, refer to the

Galaxie installation Guide.

It is also possible to give a fixed IP address to the Agilent 1100

chain. To know how to fix the IP address of the Agilent 1100

chain, refer the appendix Configuring a fixed IP address.

NOTE: The BOOTP server provided by Galaxie is installed during the installation of the

Galaxie software.

Following are examples of connections between Galaxie and

Agilent 1100 modules.

1 2 3 4 5 6 7 8 9 10 11 12 ... 183 184

Sem comentários

Agilent Technologies 1100 Series Guia de Instalação Página 7