Agilent Technologies 1100 Series Guia do Utilizador descarregar pdf (Página 29)

Agilent 1100 Series Valves 23

Maintenance, Repair, and Troubleshooting 3

Maintenance and Repair

2 Align the Stator Ring (4) that the two short pins on the ring enter the

matching holes in the body (7).

3 Insert the three Stator Ring Screws (3). Turn each of the screws an equal

amount until the they are finger-tight, then tighten them another half turn.

4 Mount the new Stator Face (5) onto the Stator Head (2). The pins on the

Stator face must fit into the matching holes of the Stator Head.

5 Assemble the Stator Head (2) and Stator Face(5) that the pin in the Stator

Ring enters the matching hole in the Stator Head.

6 Insert the Stator Screws (1). Turn each of the screws an equal amount until

the they are finger-tight, then tighten them another half turn.

Figure 11 Valve body (7) and Rotor seal (6)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 77 78

Sem comentários

Agilent Technologies 1100 Series Guia do Utilizador Página 29