Agilent Technologies E6640A EXM Manual de Serviço descarregar pdf (Página 326)

326 Chapter 20

Bluetooth Programming Commands

LE In-band Emission

Bluetooth Programming Commands

LE In-band Emission

This section provides the remote control SCPI commands for the Bluetooth LE In-band Emission

measurement from within the List Sequencer. This measurement is available only if you have the

Bluetooth measurement application licensed on the test set.

For more detailed information about the CDP measurement, refer to the online help associated with the

Bluetooth measurement application, which is also available in PDF format (“User’s and Programmer’s

Reference”) on the Agilent website, www.agilent.com/find/e6640a.

You can also refer to the measurement guide for the X-series Bluetooth measurement application, which

is available on the Agilent website, www.agilent.com/find/mxa.

LE In-band Emission measurement SCPI commands

There is a set of SCPI commands available to program the Bluetooth LE In-band Emission measurement

when it is used in the Bluetooth mode. To set up the Bluetooth measurements from within the Sequence

Analyzer mode you need to prefix the SCPI commands with LSEQuencer:BTooth. For example, the

[:SENSe]:IBEMissions part of the LE In-band Emission SCPI commands are replaced with

[:SENSe]:LSEQuencer:BTooth:IBEMissions.

The following commands are used to set up the LE In-band Emission measurement.

:CALCulate:LSEQuencer:BTooth:IBEMissions:LIMit:STATe

:CALCulate:LSEQuencer:BTooth:IBEMissions:LIMit:FAR:UPPer[:DATA]

:CALCulate:LSEQuencer:BTooth:IBEMissions:LIMit:NEAR:UPPer[:DATA]

[:SENSe]:LSEQuencer:BTooth:IBEMissions:FREQuency:SPAN

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 339 340

Sem comentários

Agilent Technologies E6640A EXM Manual de Serviço Página 326