Agilent Technologies E6640A EXM Manual de Serviço descarregar pdf (Página 132)

132 Chapter 9

Sequence Setup Commands

Programming Source Sequences (Parameter-Specific Commands)

Sequence Setup Commands

Programming Source Sequences (Parameter-Specific Commands)

Each of these commands can be used to change just one parameter of a source step within a sequence.

1: Step Number

As source steps are simply numbered sequentially within the sequence, there is no parameter-specific

command for setting the number of a source step. However, in the commands given below, it is

necessary to identify the source step by number in the STEP value.

2: Step Trigger

For a description of this parameter, see “2: Step Trigger” on page 37. The parameter-specific commands

are described below.

3: Transition Time (also known as Setup Time)

For a description of this parameter, see “3: Transition Time (also known as Setup Time)” on page 38.

The parameter-specific commands are described below.

Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:INPut:TRIGger

IMMediate|INTernal|EXTernal2|KEY|BUS

:SOURce:LIST:STEP[1]|2|3…1000:SETup:INPut:TRIGger?

Example: :SOUR:LIST:STEP2:SET:INP:TRIG BUS

:SOUR:LIST:STEP2:SET:INP:TRIG?

Remote Command: :SOURce:LIST:STEP[1]|2|3…1000:SETup:TRANsition:TIME

<time>

:SOURce:LIST:STEP[1]|2|3…1000:SETup:TRANsition:TIME?

Example: :SOUR:LIST:STEP2:SET:TRAN:TIME 1ms

:SOUR:LIST:STEP2:SET:TRAN:TIME?

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 339 340

Sem comentários

Agilent Technologies E6640A EXM Manual de Serviço Página 132