Agilent Technologies E6640A EXM Manual de Serviço descarregar pdf (Página 118)

11 8 Chapter 9

Sequence Setup Commands

Programming Analyzer Sequences (Parameter-Specific Commands)

Sequence Setup Commands

6: Number of Averages

For a description of this parameter, see “6: Number of Averages” on page 25. The parameter-specific

commands are described below.

NOTE The Number of Averages must not be greater than one when the Measurement Bit Mask

(page 128) includes Basic IQ Data.

7: Peak Power

For a description of this parameter, see “7: Peak Power” on page 25. The parameter-specific commands

are described below.

SCPI Command

To set the average number as an individual value:

[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:AVERage:

NUMBer <integer>

[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:AVERage:

NUMBer?

To set the average number as an array:

[:SENSe]:LSEQuencer:LIST:SETup:AVERage:NUMBer

<integer>,<integer>,<integer>,…

[:SENSe]:LSEQuencer:LIST:SETup:AVERage:NUMBer?

The array form of the command is used to make a different setting for each

acquisition in the sequence (the number of array values must match the

number of acquisitions; otherwise a "settings conflict" error will occur).

SCPI Examples :LSEQ:ACQ2:SET:AVER:NUMB 3

:LSEQ:ACQ2:SET:AVER:NUMB?

:LSEQ:LIST:SET:AVER:NUMB 2,3,4,5

:LSEQ:LIST:SET:AVER:NUMB?

SCPI Command

To set the peak power as an individual value:

[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:PPOWer <amp>

[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:PPOWer?

To set the peak power as an array:

[:SENSe]:LSEQuencer:LIST:SETup:PPOWer

<amp>,<amp>,<amp>,…

[:SENSe]:LSEQuencer:LIST:SETup:PPOWer?

The array form of the command is used to make a different setting for each

acquisition in the sequence (the number of array values must match the

number of acquisitions; otherwise a "settings conflict" error will occur).

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 339 340

Sem comentários

Agilent Technologies E6640A EXM Manual de Serviço Página 118