Agilent Technologies 6002A Guia do Utilizador descarregar pdf (Página 290)

E Cleaning Information How to clean instruments with a fixed connector interface

290 E6000C Mini-OTDR User’s Guide, E0302

2 Clean the lens by rubbing the cotton-swab over the

surface using a small circular movement.

3 Using a new, dry cotton-swab remove the alcohol, any

dissolved sediment and dust.

4 Blow away any remaining lint with compressed air.

How to clean instruments with a

fixed connector interface

You should only clean instruments with a fixed connector

interface when it is absolutely necessary. This is because

it is difficult to remove any used alcohol or filaments from

the input of the optical block.

Dust caps It is important, therefore, to keep dust caps on the

equipment at all times, except when your optical device is

in use.

Compressed air If you do discover filaments or particles, the only way to

clean a fixed connector interface and the input of the

optical block is to use compressed air.

Fluids and fat If there are fluids or fat in the connector, please refer the

instrument to the skilled personnel of Agilent’s service

team.

CAUTION Only use clean, dry compressed air. Make sure that the air

is free of dust, water, and oil. If the air that you use is not

clean and dry, this can lead to filmy deposits or scratches

on the surface of your connector interface. This will

degrade the performance of your transmission system.

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 319 320

Sem comentários

Agilent Technologies 6002A Guia do Utilizador Página 290