Agilent Technologies 22D Manual do Utilizador descarregar pdf (Página 8)

8 Installation Note 08720-90318

Figure 4 Assembling the High Stability Frequency Reference

Reassemble the Rear Panel

1. Replace the VGA connector with the two connector fasteners.

2. Reconnect the ribbon cable (W85) from the motherboard connector (A17J6). Reconnect the

fan harness from the motherboard connector (A17J5).

3. Carefully fit the rear panel into the rear frame.

4. Replace the four screws that surround the connector interfaces on the rear panel. Replace

the six screws that go next to the preregulator on the rear panel.

5. Reconnect W13 to A12J3 and reseat the reference board (A12) in its card cage slot. Be sure

to route W13 through the notches provided in the card cage walls.

6. Replace the pc board stabilizer.

7. Finish securing the rear panel by replacing the six screws in the top and bottom edges of

the rear frame.

8. Option 085 only: Replace the jumper cable and the two screws in the SOURCE IN/OUT

BLOCK.

9. Replace the top cover.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Agilent Technologies 22D Manual do Utilizador Página 8