Agilent Technologies 22D Manual do Utilizador descarregar pdf (Página 6)

6 Installation Note 08720-90318

Remove the Rear Panel Assembly

4. Remove the six screws (item 7) from the rear frame, two from the top edge and four from

the bottom edge. (Refer to Figure 2.)

5. Remove the screw that secures the pc board stabilizer (item 8) and remove the stabilizer.

6. Lift the reference board assembly (A12) from its motherboard connector and disconnect the

cable from A12J3.

7. Remove the six screws (item 9) next to the preregulator from the rear panel as shown.

8. Remove the four screws (item 10), surrounding the peripheral interface connectors, from

the rear panel as shown.

Figure 2 Disconnecting the Rear Panel

9. Remove the two connector fasteners (item 11) from the VGA connector.

10.Option 085 only: Remove the jumper cable (item 12) and the two screws (item 13) from

the SOURCE IN/OUT BLOCK.

11.Gently pull the rear panel away from the frame. (Refer to Figure 3.) Disconnect the ribbon

cable (W85) from the motherboard connector (A17J6) by pressing down and out on the

connector locks. Disconnect the fan harness from the motherboard connector (A17J5).

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Agilent Technologies 22D Manual do Utilizador Página 6