Agilent Technologies 22D Manual do Utilizador descarregar pdf (Página 7)

Installation Note 08720-90318 7

Figure 3 Removing the Rear Panel

Attach the Frequency Reference Assembly

12.Remove the two plastic hole plugs from the rear panel holes that are labeled: "10 MHz

PRECISION REFERENCE" and "ADJ." This is the location on the rear panel where the

high-stability frequency reference assembly will be installed.

13.Fasten the bracket (item 12) to the inside of the rear panel (item 13) with a screw (item 14)

in the location shown. (Refer to Figure 4.)

14.Place the plastic spacer washer (item 15) over the female BNC connector (item 16) on the

high-stability frequency reference board (A26).

15.Slide the high-stability frequency reference board (A26) into the bracket (item 12) and

secure it with the attaching screw (item 17).

16.Finish securing the assembly to the rear panel by attaching a washer (item 18) and nut

(item 19) to the female BNC connector that protruded through the "10 MHz PRECISION

REFERENCE" hole.

17.Connect the three-wire harness (W30) from the rear panel interface board (A16J3) to the

high-stability frequency reference board (A26J1).

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Agilent Technologies 22D Manual do Utilizador Página 7