Agilent Technologies Ininiium 9000 Especificações descarregar pdf (Página 137)

Chapter 6: Replacing Assemblies

To remove and replace the acquisition board assembly

137

Figure 6-36

Figure 6-37

Place the oscilloscope on its face (make sure the front panel cover is installed) and lift the piece

of sheet metal up to access the acquisition board (as shown in Figure 6-38).

Then remove this screw

This is the lower

right hand side of

the oscilloscope

(as viewed from

the rear of the

oscilloscope).

Finally, remove these

two screws

These are the BNCs

located in the upper left

hand corner of the

oscilloscope’s rear panel

(as viewed from the rear)

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 165 166

Sem comentários

Agilent Technologies Ininiium 9000 Especificações Página 137