Agilent Technologies Ininiium 9000 Especificações descarregar pdf (Página 125)

Chapter 6: Replacing Assemblies

To remove and replace the front panel bezzle, front panel keyboard, touchscreen, and Autoprobe board

125

board. You will need some room to work with and if you fully tighten the screws on the

Autoprobe board, you will have none. Once the front panel keyboard is attached, tighten the

Autoprobe screws to 5 in-lbs.

Figure 6-18

To remove the touchscreen, you will need to access the back side of the sheet metal it is attached

to in order to disconnect cables. There are two T15 screws on either side of the oscilloscope

that need removed (Figure 6-19) and then the front chassis will open up as shown in Figure 6-20.

Figure 6-19

Remove these

two screws

Once the screws are

removed, disengage

this latch and the one

on the other side to

lift up and remove

board

The other

latch

This is the upper

right side screw

that needs

removed to open up

the front chassis.

There is also a lower

right side screw and

two more on the left

side

Note that this picture shows the front panel keyboard still attached but if you have followed

the directions exactly to this point, it will already be removed

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 165 166

Sem comentários

Agilent Technologies Ininiium 9000 Especificações Página 125