Agilent Technologies C-Size VXIbus Systems Manual do Utilizador descarregar pdf (Página 72)

EPC7-3 : Install EXM Expansion Modules

EXM expansion modules are used for video controllers, network interfaces,

and GPIB interfaces. Some EXM modules come already installed.

However, if you have an EXM module that needs to be installed, use the

following procedure:

1. Turn off mainframe power by pressing the button at the bottom left

corner of the mainframe.

2. Slide the EXM module into place in the card guides.

3. Push firmly on the EXM module front panel to insert its rear

connector.

4. Tighten the thumb screws on the EXM’s faceplate.

NOTE When inserting a EXM module, avoid touching the circuit board and make

sure you are operating in a static-free environment.

Slide the EXM Module into the EPC7

expansion slot until it inserts into the

rear connector

Figure 2-42. Installing an EXM Module

2-54 Setting Up an Embedded RADI-EPC7 Computer C-Size Configuration Guide

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 177 178

Sem comentários

Agilent Technologies C-Size VXIbus Systems Manual do Utilizador Página 72