Agilent Technologies E6474A Guia do Utilizador descarregar pdf (Página 120)

120 Agilent E6474A User’s Guide

4 Use Your System

Tes t 7 - P h o ne Te s ting U s i ng a Tes t C a l l

Setting Up the Hardware

1 Connect the system components per the instructions in

Chapter 3.

2 Power the system on.

Testing t h e Pho n e

1 Start the E6474A software.

2 Refer to “Identifying the Devices" on page 94, and perform

the procedure if you have not already done so.

3 Configure the Autodialing options in the Properties dialog

box. Click Help in the dialog box for instructions.

4 Open the view that shows signal parameters:

5 For CDMA, click View > CDMA Phone Status.

6 For GSM, click View > GSM Signal.

7 For iDEN, click View > iDEN Signal Parameters.

8 For TDMA, click View > IS 136 Phone.

9 Click View > Call Stats to open the call statistics view.

10 Click Log > Start Logging.

Passing the Test

In the signal parameters view, you should see an indication of

signal strength and other air interface parameters. The Call

Stats view indicates the call progress and call termination

results. If all calls are logged as “blocked,” verify that service for

the phone has been activated, and that the phone’s battery is

fully charged. Also recheck all cable connections.

• Click Log > Stop to end the test.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 223 224

Sem comentários

Agilent Technologies E6474A Guia do Utilizador Página 120