Agilent Technologies Agilent B2201A Manual do Utilizador descarregar pdf (Página 156)

5-30 Agilent B2200 User’s Guide, Edition 2

SCPI Command Reference

[:ROUTe]:BIAS:CHANnel:DISable:CARD

This command bias-disables the all output ports (channels) for the specified card.

When the Bias Mode is ON, the bias-disabled output ports are disconnected from

the input Bias Port. At *RST, all cards are bias-enabled. The bias mode is set by

“[:ROUTe]:BIAS[:STATe]”.

Syntax [:ROUTe]:BIAS:CHANnel:DISable:CARD card_number

Example OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS:CARD ALL"

[:ROUTe]:BIAS:CHANnel:DISable[:LIST]

This command specifies the bias-disabled output ports (channels). When the Bias

Mode is ON, the bias-disabled output ports are disconnected from the input Bias

Port. At *RST, all channels are bias-enabled. The bias mode is set by

“[:ROUTe]:BIAS[:STATe]”.

The query returns whether the specified channels are bias-disabled or not.

Syntax [:ROUTe]:BIAS:CHANnel:DISable[:LIST] (@channel_list)

[:ROUTe]:BIAS:CHANnel:DISable[:LIST]? (@channel_list)

Input port is always the input Bias Port. So, the input ports in channel_list are

ignored. However, you cannot abbreviate the input port.

Query response disable_status{, disable_status} <newline><^END>

1: bias disabled

0: bias enabled

Parameter Explanation

card_number For Auto Config mode: 0 or ALL

For Normal Config mode: 1, 2, 3, 4, or ALL

Parameter Explanation

channel_list Channels to bias-disable or to check.

For channel_list, see “Switch Control” on page 4-5.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 233 234

Sem comentários

Agilent Technologies Agilent B2201A Manual do Utilizador Página 156