Agilent Technologies U4154A Guia de Instalação descarregar pdf (Página 36)

36 U4154A Logic Analyzer Installation Guide

2 Setting up the Hardware for U4154A

Step 6 - Connect the U4154A Module to Probes

In this step, you use the U4201A pod connector cables

shipped with the U4154A module to connect the module to

probes.

Tighten the thumb screws on the U4201A cables to connect

the cable to the relevant pod input on the front panel of the

U4154A module. Then connect the other end of the cable to

the probe.

Remember to put the correct pod labels on the pod

connector cables matching the color coding of the pods on

the front panel of the module.

CAUTION

- Do not over tighten the thumb screws. Hand tightening is

recommended or maximum torque of 3in-lb.

- Disengage thumb screws completely from module and pull the pod

straight out to remove.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Sem comentários

Agilent Technologies U4154A Guia de Instalação Página 36