Agilent Technologies U4154A Guia de Instalação descarregar pdf (Página 21)

Setting up the Hardware for U4154A 2

U4154A Logic Analyzer Installation Guide 21

Tighten the retaining screws on either end of the U4154A

module to ensure the ground connection.

After you have installed the U4154A module in the chassis,

ensure that you insert a filler module in any empty slot(s) of

the chassis. Do not operate the chassis with empty slots.

This is especially important for the slots on either side of

the U4154A module. This allows proper air flow and cooling,

and provides EMI shielding for the chassis and installed

components. Leaving slots empty can increase fan speed,

raise ambient noise, overheat components, and can cause the

module to shut down.

To remove the U4154A module from the chassis

1 Loosen the retaining screws on both ends of the U4154A

module.

2 Extend the ends of both module insertion/extraction

handles, by pulling them inwards towards each other.

CAUTION

The enclosure surface of the U4154A module may become hot

during use. If you need to remove the module, first power down the

AXIe chassis, allow the module to cool, and then pull the module out

of the chassis.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Sem comentários

Agilent Technologies U4154A Guia de Instalação Página 21