Agilent Technologies 53150A Manual de Instruções descarregar pdf (Página 108)

Chapter 4 Command Reference

:MEASure Subsystem

4-12 Programming Guide

COMMAND :CONFigure[:SCALar]:<function> <parameters> [,<source_list>]

Configures the instrument to perform the specified function but does not

initiate the measurement.

COMMENTS • Use :INITiate:FETCh? or :READ? to make and query a measurement.

• Parameters (other than <source_list>) can be defaulted by substituting

the keyword DEFault. The <source_list> parameter can be defaulted

by omitting it. The default values are specified by the particular

function description.

• This command defaults several Counter settings. To change the

function only, while leaving all other Counter settings as they are,

use [:SENS]:FUNC[:ON].

• If an <expected_value> parameter is outside the measurement

capabilities of the Counter model, an error is generated, and the

command does not execute.

• For :POWer, <resolution> must be defaulted or set to 0.01[dB].

• See “Descriptions of the Measurement Functions” on Page 4-16 for a

description of each of the measurement functions.

• See Table 4-2 for a summary of the <function>, <parameters>,

and <source_list> for each of the measurement functions.

COMMAND :CONFigure?

Queries the function configured by the last :CONFigure command or

:MEASure query.

QUERY RESPONSE • A string of the form: "<function> <parameters>[,<source_list>]."

The leading colon is omitted from the <function>.

• The response is unaffected by *RST, recall, and [:SENS]:FUNC.

COMMENTS • If the instrument state has changed through commands other than

:CONFigure or the :MEASure query, the instrument does not track

these changes, and the query response does not reflect these changes.

• For :POWer, <resolution> must be defaulted or set to 0.01[dB].

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 173 174

Sem comentários

Agilent Technologies 53150A Manual de Instruções Página 108