Agilent Technologies N5230C Guia do Utilizador descarregar pdf (Página 42)

34 User’s Guide

U3042AE12 Controlling the Test Set with N5230A

GPIB Command Processor Console

Write Commands

Once the GPIB Command Processor Console is open, commands can

remotely control the external Test Set I/O connector by sending the following:

address: a integer number

data: a integer number

Address and data are separated by a comma. Commands should be separated by a new line, or

carriage return.

For example:

CONT:EXT:TEST:DATA <address>,<data>

CONT:EXT:TEST:DATA 0,0

Example: CONT:EXT:TEST:DATA 0,0

Read Commands

address: a integer number

Address is entered, data value will be returned. Commands should be executed with a carriage

return (enter).

For example:

CONT:EXT:TEST:DATA? <address>

CONT:EXT:TEST:DATA? 0

Example: CONT:EXT:TEST:DATA? 0

This command reads the decimal equivalent of the binary data from the specified address.

The example shown above illustrates address is 0 and the returned data is 8191. Refer to

Table 16 on page 62.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 101 102

Sem comentários

Agilent Technologies N5230C Guia do Utilizador Página 42