Agilent-technologies E1300B Manual do Utilizador descarregar pdf (Página 112)

Transmitting Using a CAT

Command

On HP-UX systems you can use the cat command to transfer the device driver.

The appropriate device file must exist. All shell commands are assumed to be

executed from either the /bin/sh or /bin/ksh shell.

1. Start a process that opens the device file to be used. This process should

keep the device file open long enough for the transfer to begin. This step

is done so that the following command to set the device file

configurations will remain in effect for the transfer. A command that will

do this is:

(cat < device file > /dev/null; sleep 1000) &

2. Set the required configuration of the device file using the stty command

The following command will set the device file to work with the default

System Instrument configuration.

stty -opost 9600 ixon -ixoff cs8 -cstopb ignpar < device file

3. Transfer the file to the System instrument with the cat command.

cat filename > device file

Transmitting Using Custom

Software

If the COPY command on your computer cannot directly implement

handshaking, or if you wish to trap errors and abort or otherwise modify the

transmission process, you must use a program to handle the download process.

This procedure assumes that your computer has some means of looking at data

being echoed from the System Instrument, and can check for a return character

without having to have a character returned. Since the actual driver file bytes

sent over the RS-232 interface are not echoed, the lack of ability to do this

would put the system into an infinite wait at the first byte that was not echoed.

1. Set up the appropriate handshake mode and data format on your system,

and the matching handshake mode in the System Instrument.

2. Transfer the driver file over the RS-232 interface using a program that

follows the outline in figure 5-3.

Check Driver Status Make sure that the drivers were properly downloaded by checking their status

using the DIAG:DRIV:LIST:RAM? command. This will give you a list of all the

drivers currently found in DRAM.

5-14 Downloading Device Drivers

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 243 244

Sem comentários

Agilent-technologies E1300B Manual do Utilizador Página 112