Agilent-technologies J3972A Manual do Utilizador descarregar pdf (Página 125)

Download New Firmware

Downloading Firmware using an HP-UX Workstation and a Terminal

105

3. Verify that the probe’s IP address, subnet mask, and default gateway

address, as displayed at the bottom of the Download Menu screen, are

correct. If you need to change the configuration information, press

return to the main menu and then press

to modify configuration options.

4. Press

from the Download Menu screen, and enter the filename to

download.

5. Press

and enter the IP address of the HP-UX workstation which is acting

as the tftp server.

6. Press

to download new probe firmware and wait for the probe to reboot

automatically. It should take about 90 seconds to transfer the firmware to the

probe and for the automatic reboot to take place. The probe relays will click

at the end of the reboot process.

CAUTION

Do not reset, power-cycle, or reboot the probe immediately after the download

process. Doing this may cause your probe to be damaged. After the firmware file

has been downloaded to the probe, there will be a brief period (approximately

1 minute) while the probe is copying the firmware to the flash EPROM.

After the download process is complete, the probe reboots and starts running the

new firmware.

If an error occurs during the download process, the probe returns to the Main

Menu without storing the new firmware to memory.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 188 189

Sem comentários

Agilent-technologies J3972A Manual do Utilizador Página 125