Agilent Technologies 8000 Series Guia do Utilizador descarregar pdf (Página 102)

Using the Oscilloscope

To set an edge trigger

3-57

To set an edge trigger

1 Click on the trigger setup button at the bottom of the waveform display.

This brings up the trigger configuration dialog. See “To access the trigger

setup.”

2 Click on Edge.

3 Click on the source you want to use for the trigger signal.

4 Click to select either the rising or falling edge of the trigger source.

5 Set the trigger level using the spin box.

You can also click on the trigger level setting to display a pop-up numeric

keypad, where you can enter the trigger level directly.

Figure 3-40

Setting an Edge Trigger

Select Triggered

sweep (or Single for

single-shot

acquisition)

Select rising or

falling edge

Set the trigger level

using the spin box

controls

Select the trigger

source

Select Edge mode

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 128 129

Sem comentários

Agilent Technologies 8000 Series Guia do Utilizador Página 102