Agilent Technologies E1300B Manual do Utilizador

Agilent 75000 SERIES BE1300B/E1301B MainframeE1306A Command ModuleMemory ModuleInstallation NoteCopyright© Agilent Technologies, Inc., 1995, 2006*E130

Step 9: Remove the controller module’s ribbon cable connector(s) (the E1300 has one ribboncable, the E1301 has two cables). Push the controller modu

For example, in the figure above, the four Most Significant Bit (MSB) switches are shown in the "1" position,the next bit is shown in the &

Step 12: Reassemble the mainframe.Step 11: Install the memory module(s) and fasten with the Torx® screws provided.1-8 Installing Memory into an Agi

Chapter 2Installing Memory into anAgilent E1306A Command ModuleDescriptionYou can install one or two 1MByte memory modules into an Agilent E1306A Co

Installation ProcedureStep 1: If the Agilent E1306A Command Module is installed in a mainframe, disconnectpower to the mainframe and remove the Comma

Step 3: Set the memory module address switch(es) according to Table 2-1.For example, in the figure above, the four Most Significant Bit (MSB) switch

Step 4: Install the memory module and fasten with two Torx® screws.Step 5: (Optional) Install second memory module and fasten with four Torx® scre

CertificationAgilent Technologies certifies that this product met its published specifications at the time of shipment from the factory. Agilent Tech

Frame or chassis ground terminal—typi-cally connects to the equipment’s metalframe.Alternating current (AC).Direct current (DC). Indicates hazardous v

Chapter 1Installing Memory into an AgilentE1300B/E1301B MainframeDescriptionYou can install one or two memory modules onto the controller circuit boa

Installation ProcedureStep 1: Disconnect the mainframe’s power.Remove with Phillips orPozi-drive ScrewdriverStep 2: Remove the mainframe’s side handle

Step 4: Slide the top cover toward the rear, lift and remove the cover.Remove with T10 Torx KeyStep 3: Remove the Torx® screws on the rear of the ma

Step 6: If you have an internal Agilent E1326 5 1/2 Digit Multimeter, disconnect the BNCcable, and remove the three Torx® screws. T10 Torx ScrewSpac

Step 8: Remove the three T10 Torx® screws securing the controller board.Step 7: Remove the multimeter.Installing Memory into an Agilent E1300B/E1301