Agilent Technologies E2094S Manual de Serviço descarregar pdf (Página 118)

118 Agilent Connectivity Guide

5 Connecting Instruments to LAN

5 Run the Microsoft Telnet Client. (On Windows XP, click Start >

Run and type

telnet

6 At the Telnet command line, type:

open XXX.XXX.XXX.XXX PPPP

where XXX.XXX.XXX.XXX is the instrument’s IP address and

PPPP is the port (5024 for most Agilent products). You should see a

response from the instrument, such as:

Welcome to Agilent’s 33220A Waveform Generator

7 Enter commands for the product. CTRL-C is typically a device clear;

check your instrument documentation for other commands.

8 Close the Telnet window to close the connection to the instrument

and exit Telnet.

Add a LAN interface

One LAN interface labeled LAN (TCPIP0) appears in the Explorer Pane

by default. If there is not a LAN interface available, or you wish to

connect instruments via LAN with different connection parameters

(such as different connect time-outs), then take the following steps:

1 Click Add Interface on the Connection Expert toolbar to create an

additional LAN interface.

2 When the Manually Add an Interface box appears with LAN

interface highlighted, click Add.

3 When the LAN Interface configuration box appears, modify the

properties as desired, then click OK.

NOTE

The required Auto-discover setting for LAN interfaces is off. To

prevent disrupting network traffic, Connection Expert does not

automatically query each bus on the LAN to detect new devices.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 217 218

Sem comentários

Agilent Technologies E2094S Manual de Serviço Página 118