Agilent Technologies 4294A Manual de Serviço descarregar pdf (Página 104)

100

101

104 Chapter 7

Processing Measurement Results

Analyzing Measurement Results

Figure 7-2 Trace bandwidth analysis

Use the following command to read the results of trace bandwidth analysis.

• “OUTPMWID?” on page 390

You can use the following command to search for a measurement point that meets the

cutoff point requirements and that is located outside the cutoff point found during the

initial search.

• “WIDSOUT” on page 461

Use the following command to return to the initial cutoff point from the measurement point

found using the above command.

• “WIDSIN” on page 460

Example 7-3 shows a sample program for trace bandwidth analysis. This program is

available under the filename “band_ana.bas” on the sample program disk.

This program performs a sweep once, searches for the bandwidth, and reads and displays

the results of trace bandwidth analysis.

Lines 30 to 70 Identifies the external controller and Instrument BASIC and sets the

GPIB address.

Lines 90 to 110 Substitutes the sweep center value, the sweep span value, and the trace

selected as the active trace into the corresponding variables Cent,

Span, and Act_trc$, respectively.

Lines 130 to 160 Resets the Agilent 4294A, sets impedance amplitude and phase as

measurement parameters, and sets the sweep center value and the

sweep span value to Cent and Span, respectively.

Lines 170 to 190 Performs a sweep once and waits for the sweep to be completed.

Lines 210 to 220 Sets the active trace to Act_trc$ and executes the auto scale to

automatically set the scale parameters so that the waveforms fit on the

screen.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 517 518

Comentários a estes Manuais

Sem comentários

Agilent Technologies 4294A Manual de Serviço Página 104

Comentários a estes Manuais

Manuais e produtos relacionados com Multímetros Agilent Technologies 4294A